 Re: strain gauge Quickshifter from WRT?? |
| How is the quickshifter holding up, I'm wondering how it will hold up |
| |
| Re: strain gauge Quickshifter from WRT?? |
in my opinion after 1 test superb  nice just turn off cut from 1000 to 4000 end is good |
| |
| Re: strain gauge Quickshifter from WRT?? |
| for gsxr1000 07-11
Race Tools installation manual,there are several plugs on the Race Tools harness
On one end of the harness there is 2 6 pin SDS diagnostic plugs close together, plug the relevant plug into SDS plug on your bike.
On the other end of the harness is a single plug (similar to the SDS plug), plug this into the 6 pin Exhaust Valve plug on your bike's harness.
Then plug the 3 pin plug into the matching 3 pin plug on the quickshifter. |
| |
| Re: strain gauge Quickshifter from WRT?? |
| gsxr1000 07-11 |
| |
| Re: strain gauge Quickshifter from WRT?? |
I had same problem, on gsxr 1000 k9 exhaust servo connector is different, this is haw need to be connected.  |
| |
| Re: strain gauge Quickshifter from WRT?? |
| this is the set what you will get |
| |
| Re: strain gauge Quickshifter from WRT?? |
Slight issue in gsxr1000 9-11 it doesn't shift over 6000rpm.  |
| |
| strain gauge Quickshifter from WRT?? |
| anyone tested new strain gauge Quickshifter from WRT???? |
| |
| |
| View Topic on the Woolich Racing Forums |