 GEN II Auto Shift Issue |
Well got everything wired up and took her out for a test run.
I am using the ECU editor for a 2 step, shift light, and auto shift with the pass button for a manual shift (co2 shifter)
Everything works great!! Except I cant get the autoshift to work. 
I am coming off my pair valve signal going to activate a relay which kills the ignition and fuel.
When it gets to the set rpm (which ive tried 5500-10,000) the shift light comes on and the ignition and fuel are killed but no shift
When I activate the pass switch all works great!! 
So I figured ok maybe the signal isn't long enough from the pair valve so I added in a multi function timer.. goes as the following.... pair valve signal wire goes to the time relay,, time relay send a ground to the shift relay for a determined amount which in the case it was .05 sec still samething, shift light comes on engine kill but no upshift.
The onlything I am not 100% sure on is the 2 wires on the pair valve.
I am using the signal wire at the pair valve, t tapped in. Are you disconnecting the pair valve out of the circuit compleltly or t tapping in the - signal? |
| |
| |
| View Topic on the Woolich Racing Forums |