 Re: engine data - wiring harness only |
| Yes that indicator needs to be green.
Please check the following:
Interface should be in Engine Data Mode
Harness is correctly installed, check plugs and circuit continuity from the ECU plug through to the white molex plug
Check that the same "Fast Baud Rate" setting is selected for the bin file in the ecu and in the software
Please also try the Engine Data module in the Woolich Racing Tuned (WRT) software |
| |
| Re: engine data - wiring harness only |
| Hy!
I tried to get engine data with ecueditor, but was not successful. Before switching to
engine data mode, I flashed with the generic mode set. When I open the engine data
panel, there is a yellow signal in the connection box. Am I right, that this one has to
be green in order to get data? |
| |
| Re: engine data - wiring harness only |
| Thank you very much! |
| |
| Re: engine data - wiring harness only |
| Generic |
| |
| Re: engine data - wiring harness only |
| Sorry for that stupid question, but which type should be selected in order to deactivate the immobilizer? |
| |
| Re: engine data - wiring harness only |
| depends on the ECU Type selected. |
| |
| Re: engine data - wiring harness only |
| And ist it necessary to have a key switch installed?
I was able to flash the ecu, so the immobilizer should be deactivated.? |
| |
| Re: engine data - wiring harness only |
| Hi, yes you need to have all of the required signals connected to the ecu so it is in a state where it could/would start the engine.
Ignition On
Engine Kill Switch in run position
Clutch In
The engine does not have to be running to get Engine Data. |
| |
| engine data - wiring harness only |
| Hy there,
i've got a question regarding the engine data function in ecueditor.
What is required for getting data?
- ignition switch on
- engine stop switch off, side stand relay off
Are these switches enough, or is it necessary to have a key switch with a plugged key too?
Does the engine has to run?
We would like to get data with the removed harness for adjusting.
Thanks for any reply!
greets from austria,
stefan |
| |
| |
| View Topic on the Woolich Racing Forums |