 Re: Need ECU Editor to FLASH! |
| It will not be anything to do with WRT as WRT simply does not make any changes to this part of the bin file no matter what you do in the software or when you open a bin file to write etc. I know this because i wrote both the extended boost fuel in ecueditor as well as the whole WRT program.
I will send you a ticket to discuss further. |
| |
| Re: Need ECU Editor to FLASH! |
| If it is easier please email me at semilligan3@gmail.com |
| |
| Re: Need ECU Editor to FLASH! |
| On the boost fuel page, top right, the voltage settings aren't changing each time I save it and flash it with woolich. The fuel values change but the 3 bar calibration isnt. For example, if I put 0.5 volts at 0 kpa and 343 at 4.5 volts or if I put 0.5 volts at 100 kpa and 5.0 volts at 800 kpa. After flashing them, I can pressure test the system and at an actual boost value of 13.2 the ECU still shows 10.6 PSI. It's not changing no matter what I set it at. |
| |
| Re: Need ECU Editor to FLASH! |
| sorry maybe i am not understanding something, but isnt the setting you are talking about part of boost fuel? Where is it "off" the same amount? |
| |
| Re: Need ECU Editor to FLASH! |
| it's not the boost fueling that isn't changing, it's specifically the voltage range setting for the 3 bar. No matter what I do, it never changes. It is always off the same amount. How can I flash it and unlock it so I can flash with ecu editor and verify that's not the problem? |
| |
| Re: Need ECU Editor to FLASH! |
| Nothing changes "behind the scenes" with the boost fuel code when you open an ecueditor bin file in WRT. I realize the first assumption is that it is a software issue but this is extremely unlikely. Can you please check the pressure sensor, harness and other hardware related things on the bike.
To verify the above, you can create a bin file in ecueditor, make the boost fuel changes, save it, open it in wrt, save it, then open it in ecueditor again. nothing would have changed. |
| |
| Need ECU Editor to FLASH! |
| Well, I've used ECU Editor on my turbo bike for awhile now and I use Woolich on my Drag Bike and I recently flashed the turbo bike with Woolich just testing something and now ECU Editor says the "No unlock ACK......." so I understand that I can edit it in ECU Editor and flash it with Woolich. Well initially I was just upset because that's a pain to be running 2 programs. But now I need to edit my 3 bar sensor values in ECU Editor to get the ECU seeing the correct boost values, but they aren't getting flashed into the ECU.
I have tried putting MAX values in to adjust the 3 bar voltage pressures and still get the same results. It seems that somewhere in the saving in ECU Editor and flashing with Woolich, that the updated 3 Bar Values are not getting transferred over. So my bike is down right now because at a boost levels of 13.2 PSI my ECU thinks its at 10.6.
I've submitted a support ticket initially due to just not wanting to use 2 programs, but now I can't adjust my 3 Bar Sensor. |
| |
| |
| View Topic on the Woolich Racing Forums |