The most common reasons the write process is interrupted are:

• Harness Connection/Installation issue:
  • Check the Installation Guide and double check each step of the install.
  • Check you have fitted any extension harness correctly to the ECU plug.
  • Check all the wires are firmly locked into the ECU plug, and are not loose.
  • Check your diagnostic plug is clean, and making good contact (if used)

• Low or Loss of Power to the ECU:
  • Battery power should be 12.8v or more.
  • Run/Stop switch must be in the RUN position.
  • Check for a loose connection between the Interface and the ECU
  • Do not move the interface/harness during flashing (aka loose connection)
  • Connect a battery charger at the same time, (So the battery does not drain while flashing)
  • Check you are switching the Ignition key on/off at the right time. (follow software prompts)

• Computer interrupted the write process:
• PC should be checked that all updates are installed, and has been restarted.
• Check the PC is not busy doing background tasks
• Check your PC is powerful enough to keep up with the ECU write speed (Minimum Dual Core 2.4Ghz, 4 Gig Ram. Recommended i5 with 8 Gig Ram)
• Check your USB port is not worn out (try another USB port)
• Use the supplied USB cable. Do not use a long cable.
• Check your PC Battery is fully charged if using a Laptop.