The following are the steps to read an ECU using the Woolich Racing Tuned software:
-
Install Harness according to the Installation Instructions.
-
Connect the Interface to the harness.
-
Connect the Interface to the computer with the supplied USB cable. Please note that we recommend using a high-speed USB port.
-
Ensure Interface is in ECU flashing mode (red LED on).
-
Open Woolich Racing Tuned Software.
-
Open the bin file definition for your model (click the "New" button then select the manufacturer, model, year and part number).
-
Turn the bike ignition on, gear in Neutral, Kill Switch in the RUN position or turn the power supply on for bench flashing.
-
Click the "Tools"=>"Read ECU" menu item.
-
The WRT software will connect to the ECU and read the bin file from the ECU into memory.
N.B. If you are performing multiple flashes with a V1 & V2 Interface only, remember that you need to have cycled the interface into the center mode position then back to
flashing mode before attempting another write/read operation. The V3 Interface requires the switch on the Right Hand Side at all times for Reading, Writing, Data Logging and Diagnostics.
Was this helpful?