Log Box v1 problem

Questions and support for the Woolich Racing USB Interface (Denso and Mitsubishi)
mjwilliams
Posts: 20
Joined: Sun Apr 28, 2013 6:45 pm

Log Box v1 problem

Postby mjwilliams » Sun Sep 03, 2017 7:33 pm

I have the old Woolich v1 log box and it had been acting up causing the bike to shut down.
So I was going to upgrade to the newest stuff but they don't have the pro log box available yet so I'm holding off until then.
When we tuned the bike on the dyno we used the tuner's v1 log box and it flashed the ECU and would give real time engine data fine using my laptop.
He is letting me use his box to run the CO Mile next weekend.
The problem is when I plug his box in the USB port on my computer it says Windows does not recognize it and it has malfunctioned, etc. which means I can't read any AFR data that would be on the chip.
My old box reads fine when it is plugged in.
I'm trying to figure out what is going on but I'm not that smart and don't want to take a chance of screwing up his log box.

mjwilliams
Posts: 20
Joined: Sun Apr 28, 2013 6:45 pm

Re: Log Box v1 problem

Postby mjwilliams » Mon Sep 04, 2017 6:39 pm

Went into ECU Editor and reloaded the COM port drivers.
Took care of my issues.